Altium Set Relative Origin. Under the advanced tab of the gerber setup dialog, you have the following three options for the position on film: Next, we will create the pcb.
Git is a formidable tool, and git for hardware gives pcb designers a comprehensive workflow for version control, sharing, and revision management. This command is accessed from the pcb library editor by choosing the edit » set reference » pin 1 command from the main menus. I think you use the command place 3d body to place the step model.
Edit to change the x position of the object. Edit the value in the field to change the position of the arc relative. Designers now have the ability to set specific parameters between same net objects when placing primitives on a board.
This command is accessed from the pcb library editor by choosing the edit » set reference » pin 1 command from the main menus. This command is used to define a location in the workspace as the new (relative) origin and resets its coordinates to 0, 0. Access this command is accessed from the pcb editor.
I think you use the command place 3d body to place the step model. Altium designer world’s most popular pcb design software; Thanks ♥ subscribe radas ♥ :
After launching the command, the cursor will change to a. To set the current origin back to. On the bottom left hand side there is a snap points.
It is used to mark the x (horizontal) and y (vertical) distance of a point in the design workspace relative to the current origin. We can't rely on the relative ecad origin because it can be easily changed in ecad, and it's not realistic to. You can set the origin of the step model when you place it.
Comments
Post a Comment